1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

sub question

Discussion in 'Interior' started by jubei71, Dec 29, 2006.

  1. Offline

    jubei71 Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    sub question

    i got a bandpass enclosure for my 94 rolla both subs r 500w each im thinking of getting this amp thats 1000w (2x500 and 1x1000)and bridge it to max it out...now theres only one port for the speaker wires which is why im gonna bridge it..now is this amp good to go to power these up and how r the wiring for enclosers in series or parallel thanks alot
    jubei71, Dec 29, 2006
    #1
  2. Offline

    robthompson46 New Member

    Message Count:
    61
    Likes Received:
    0
    Trophy Points:
    0
    you have to be careful with a two channel amp. if the subs are wired up at 2ohms than you could possibly fry your amp. if you hook up a 2ohm load to a 2 ch amp, it makes the amp run at 1ohm and if its not a really high dollar good amp that is stable at 1 ohm than you'll fry it. it might not happen immediatly but over time it will. i would suggest getting a mono block class D
    robthompson46, Apr 9, 2007
    #2
  3. Offline

    robthompson46 New Member

    Message Count:
    61
    Likes Received:
    0
    Trophy Points:
    0
    oh and make sure you look at the rms of your subs instead of the max cause thats what blows subs
    robthompson46, Apr 9, 2007
    #3

Share This Page