I think they need pressed in and/or out. What year ??
When I put my new drums on (with original shoes) it felt weak at first and then got better. (they are not the most effective ever) Be careful with...
The surface mount LEDs would be a real challenge, of course still possible.
Crafts store / translucent binder from office supply store.
Hey, 2krolla I have the wiring info if you need it, PM with E-Mail address and I will get it to you. The swap for those years is 100% P&P....
What about the other speedo section is it o.k. ? Does the needle drop down to the peg when car off ? Did you take the face or the needle off ?
Harness wiring adaptors are available at www.metraonline.com Antenna is separate wiring and no adaptor needed.
I have looked over most of the TSBs for the 00 Corolla, They added "plate washers" to the fronts top 3 strut bolts/nuts (the ones in the engine...
Yes, part # 83482-02010
The fronts seem to tighten a bit more, If someone got happy with the impact gun that could be the problem. I have a small Metric 4 way lug wrench....
www.1sttoyotaparts.com $40 shipped, I avoid our local Toyota dealership when possible.
Make sure it clicks in place, Would not want to loose that $$ part. I released the plug and wire from the mounting hole (plastic clip), then you...
Yes, Temp works if you get the sensor. Total mileage is stored in the speedometer section, Easy to change to keep mileage correct. (but not in this...
If you go to www.car-part.com and select speedometer it has a big list of all the different combinations available. I think the white faces started...
Sorry, my info was based on an 01 and this is the reason why ^^^
Well, it is at 102k miles, I have no leaks and no excessive bouncing. Just slight noise on certain bumps and potholes. The car has not been driven...
I have always been an OEM fan, (and still so) But, will only have the car 1-2 more years and all OEM would get kind of $$. Trying to save some money...
Aftermarket, Front strut/spring combination 98-02 Corolla Does anyone know of an available mfgr for the "ready to install" strut/spring combination...
Peel off the plastic covers on the 3 child seat anchors, that will reveal bolt heads for removal of these. There may be a few plastic pins also...
Have you looked when the doors are open, for the rubber cover that goes between the door and the body that would hold the wires if they were there ?...
Separate names with a comma.
