heh this is interesting. too much oil pressure? and the bearings go bad often? lol. this is probably more complicated than just simple "not enough...
well in my opinion, either way the oil reaches the rod bearings last - that is why they often fail, especially in the 1zz cuz the pump is just too...
MWR tuned their MR2 correctly. and the rod bearings went. the 1zz cant afford to lose more oil then it already has flowing through the block by...
lost... I have a 98 corolla pretty much stock right now. i checked the compression yesteday and its still good. the oil passages would need to be...
ok so i checked the compression yesteday and its still good. the oil passages would need to be cleaned out with some sort of oil flush, but its not...
heh. well i was just thinking of ways to hit 200 hp reliably without spending like 10K. my motor's not looking too clean inside(burned deposts under...
is that 30-40 over stock or just from the ITB's?
HP gain from ITB's? does anyone know approximately how much HP i could gain from ITB's, standalone computer, stage 2 cams, and a full exhaust on a...
ITB's max gain approximately how much HP can you gain from ITB's on a non-vvti 1zz-fe engine with full exhaust and stage 1-2 cams and standalone? i...
FMU's wont work on your car. you have a returnless system. unless you mean like a emanage "Fuel Management Unit"
get a greddy oil filter block. or the fitting that was mentioned somewhere that can support a few senders.
you obviously know nothing about tuning 2004CE. i used to own a mitsubishi mirage(same chassis as an evolution. i've actually gotten together the...
forget it! you'd have better luck trying to swap a supra motor in.
i guess it depends on how much boost you want to run . guess the stock pump would be ok for low-boost setup, < 5 psi. i would also upgrade...
wow no one has any opinions at all? did anyone actually read the link i posted, or is it that no one knows the ECU's limits? or is it just that...
if no one has any ideas about his, i'll call TRD and ask them. if i get this to work, i'll let you guys in on the injector and MAP specs so that you...
you see, all this does is change the scale on the fuel and timing maps. the ECU will see atmospheric pressure when you run 14 psi boost on a 2 bar...
is this possible on the 1zz-fe? "on the vvti motor its pretty much impossible to cause detonation or pings by using the technique like rolling the...
he 1st only checked off "estimated". which i suppose is valid cuz he can estimate anything he wants - its not an accurate measurement or anything and...
nah theyre required to. there are check boxes that say estimated/radar/lidar. and theyre supposed to check them off so that the court will know what...
Separate names with a comma.
