1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

sub question

Discussion in 'Interior' started by jubei71, 2006年12月29日.

  1. Offline

    jubei71 Guest

    Message Count:
    0
    ライク受信:
    0
    賞:
    0
    sub question

    i got a bandpass enclosure for my 94 rolla both subs r 500w each im thinking of getting this amp thats 1000w (2x500 and 1x1000)and bridge it to max it out...now theres only one port for the speaker wires which is why im gonna bridge it..now is this amp good to go to power these up and how r the wiring for enclosers in series or parallel thanks alot
    jubei71, 2006年12月29日
    #1
  2. Offline

    robthompson46 New Member

    Message Count:
    61
    ライク受信:
    0
    賞:
    0
    you have to be careful with a two channel amp. if the subs are wired up at 2ohms than you could possibly fry your amp. if you hook up a 2ohm load to a 2 ch amp, it makes the amp run at 1ohm and if its not a really high dollar good amp that is stable at 1 ohm than you'll fry it. it might not happen immediatly but over time it will. i would suggest getting a mono block class D
    robthompson46, 2007年04月09日
    #2
  3. Offline

    robthompson46 New Member

    Message Count:
    61
    ライク受信:
    0
    賞:
    0
    oh and make sure you look at the rms of your subs instead of the max cause thats what blows subs
    robthompson46, 2007年04月09日
    #3

TRDの愛を広める