1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Engine TRD SUPERCHARGER X100

Discussion in 'Powertrain' started by Irvin, Aug 8, 2012.

  1. Offline

    crolla "Wait did I just lose to a corolla?"

    Message Count:
    507
    Likes Received:
    78
    Trophy Points:
    578
    Location:
    Maryland
    Vehicles:
    ZZE110
    Sounds good
  2. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    Yep. That's EXACTLY how the Matrix and This motor began to go. Around 3k rpm it would make a slight knocking sound that made you hope it was coming from the head. But It's not... :(
    Added: Sep 28, 2012 4:45 AM
    I started working on it for a few hours today. It's pretty much all done. Just need fluids and reconnect the exhaust. Can't wait to get back to boostin!
  3. Offline

    1nicetrd Well-Known Member

    Message Count:
    934
    Likes Received:
    304
    Trophy Points:
    613
    Yeah even my friend was live you have some loud valves ! until you showed me this i have a rod knock... you think new bearings will fix it ?
  4. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    I wouldn't just change the bearings bro. Usually when a bearing spins, even if it's just slightly, will warp the crank and rod. You could always try it but I hope this isn't your only ride. But if you're going to go that route. You best do it asap before you completely spin that sucker.
  5. Offline

    1nicetrd Well-Known Member

    Message Count:
    934
    Likes Received:
    304
    Trophy Points:
    613
    dang =( i was thinking of ordering maybe the undersize bearing from MWR, i might be fudged
  6. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    You mean Oversized bearings. You definitely need to regrind the crank with an over sized bearing set.

    Take your pan off. Rod caps. Get yourself a "good" dial caliper and measure the damaged journal several times to make sure they're still even throughout. If it is, then just get the same bearings. There should be a stamp on the side of the bearing reading "A, B or C". Order that from toyota.
  7. Offline

    1nicetrd Well-Known Member

    Message Count:
    934
    Likes Received:
    304
    Trophy Points:
    613
    OK cool ! i need to do something any ways because i am burning oil every wash i have carbon all on my trunk and bumper ... complete pain in the A$$
  8. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    Yeah. You need a full engine rebuild. Redo the bearings and pistons. I'd recommend just buying a used engine bro.
    I don't trust these rebuilt engines people sell. Find a 2005-2008 under 50k miles. It'll be cheaper than buying or having yours rebuilt.
    Added: Sep 28, 2012 5:29 AM
    GET yours at LKQ. They have the biggest inventory, network and best warranty. Their engines come with 6 month 6000mile warranty on parts. If you pay 125 more you get warranty on the labor too. If you pay 225 more you get 12 month 12000 mile warranty on parts and labor.
  9. Offline

    MacktasticSlick TRD whore with 36,000 posts, bitch

    Administrator
    Message Count:
    36,593
    Likes Received:
    2,274
    Trophy Points:
    61,368
    LKQ is great I get stuff from there, family discount yo
  10. Offline

    Machupicchu The once a week type of member

    Message Count:
    612
    Likes Received:
    62
    Trophy Points:
    58
    Location:
    Sacramento
    Vehicles:
    01 Corolla S E110
    TRD Forums discount yo?^
  11. Offline

    MacktasticSlick TRD whore with 36,000 posts, bitch

    Administrator
    Message Count:
    36,593
    Likes Received:
    2,274
    Trophy Points:
    61,368
    Depends what you need yo?
  12. Offline

    crolla "Wait did I just lose to a corolla?"

    Message Count:
    507
    Likes Received:
    78
    Trophy Points:
    578
    Location:
    Maryland
    Vehicles:
    ZZE110
    Is the car back up and running?
  13. Offline

    MacktasticSlick TRD whore with 36,000 posts, bitch

    Administrator
    Message Count:
    36,593
    Likes Received:
    2,274
    Trophy Points:
    61,368
    Yes it is thank you for asking. Oh not me? **leaves
  14. Offline

    Hummer Well-Known Member

    Message Count:
    26,893
    Likes Received:
    1,455
    Trophy Points:
    1,018
    Location:
    Oregon
    Vehicles:
    E39 BMW
    *posts to point out the hilarity in said above post ^^
    MacktasticSlick likes this.
  15. Offline

    Goldy Well-Known Member

    Administrator
    Message Count:
    32,006
    Likes Received:
    2,879
    Trophy Points:
    61,468
    Usually a "like" or a "lol" suffices lol.........


    ............. usually
  16. Offline

    Hummer Well-Known Member

    Message Count:
    26,893
    Likes Received:
    1,455
    Trophy Points:
    1,018
    Location:
    Oregon
    Vehicles:
    E39 BMW
    Fuck you gold.
  17. Offline

    Goldy Well-Known Member

    Administrator
    Message Count:
    32,006
    Likes Received:
    2,879
    Trophy Points:
    61,468
    *posts to point out the hilarity in said above post ^^
    Hummer likes this.
  18. Offline

    Goldy Well-Known Member

    Administrator
    Message Count:
    32,006
    Likes Received:
    2,879
    Trophy Points:
    61,468
    Berbles! hahahaha
  19. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    Yes it's up and running as of today.. It wasn't the head gasket. LKQ plugged the water jacket with a small plastic plug they usually put on the openings of the engine. They put a plug too small for the port and it fell it. I never saw it because it was already in the engine. Took the water pump, thermostat housing off and saw a small red plastic piece wedged inside deep.
    I fished it out and it's all done. Engine runs effin great!!!
  20. Offline

    Goldy Well-Known Member

    Administrator
    Message Count:
    32,006
    Likes Received:
    2,879
    Trophy Points:
    61,468
    Woooooooo hoooooooooooooo :)
  21. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    Engine runs strong. But to get full potential of the superduper. You definitely need a tuning computer. Either piggyback or stand alone. 8th gen works well but still pings. Celice ECU works but the car runs too rich and actually makes the car run slower than the 8th gen.
  22. Offline

    James Bullshit Police

    Moderator
    Message Count:
    15,364
    Likes Received:
    980
    Trophy Points:
    943
    Location:
    Vehicles:
    ZZE110, MA70, JZA70, AE92 GT-S x2, xB with a rollcage, 900 ft-lb Dodge Ram
    Shit, let's get some PFC's and go dyno tuning baby!
  23. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    Are you still planning on supering your corolla?
  24. Offline

    crolla "Wait did I just lose to a corolla?"

    Message Count:
    507
    Likes Received:
    78
    Trophy Points:
    578
    Location:
    Maryland
    Vehicles:
    ZZE110
    You can get emanage ultimate for like 150 used
  25. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    I'd have to research the ultimate better. My main concern is closed loop operation with the greddy
  26. Offline

    James Bullshit Police

    Moderator
    Message Count:
    15,364
    Likes Received:
    980
    Trophy Points:
    943
    Location:
    Vehicles:
    ZZE110, MA70, JZA70, AE92 GT-S x2, xB with a rollcage, 900 ft-lb Dodge Ram
    There is a great thread on how to tune out LTFTs to get stable closed loop operation. It just takes months!
    http://newcelica.org/forums/showthread.php?t=264746

    Yes definitely, but it is third in line.... I have a busted R154 that I need to some how replace/rebuild, and a busted 7M that needs to be replaced with a 1JZ. Almost ready to do everything, just never pulled/installed an engine before so a little stuck. After that shit is done, I just need to buy a PFC and the 9th gen radiator hose and we can go tuning!!!!!
    Added: Oct 10, 2012 2:17 AM
    I have only seen EMB for that price, I would jump on an ultimate if I could find it for $150!
  27. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    Lol I don't feel like taking months to tune my closed loop. I'm thinking about trying the split second AIC. It's only 269 and has decent gains.
  28. Offline

    crolla "Wait did I just lose to a corolla?"

    Message Count:
    507
    Likes Received:
    78
    Trophy Points:
    578
    Location:
    Maryland
    Vehicles:
    ZZE110
    lol i only saw it once. But yes usually i see the blue for that price. What about tuning with vafc?
  29. Offline

    Irvin Well-Known Member

    Message Count:
    2,362
    Likes Received:
    394
    Trophy Points:
    633
    Location:
    San Leandro and M0desto CA
    Vehicles:
    2002 Corolla S / Lexus LF-A / 1991 MR2 V6 / Pokeball
    I'm looking for something I can tune using my laptop. That way I can tune actual fuel trip and ignition cells.
  30. Offline

    James Bullshit Police

    Moderator
    Message Count:
    15,364
    Likes Received:
    980
    Trophy Points:
    943
    Location:
    Vehicles:
    ZZE110, MA70, JZA70, AE92 GT-S x2, xB with a rollcage, 900 ft-lb Dodge Ram
    I like the PFC because it's an entry level standalone. It will self tune the idle, idle with accessories, idle with a/c, then it's just a matter of going cell by cell on the dyno. Full control of fuel, timing, and vvt-i.

    AIC1 looks like it's just fuel control, but I bet your timing is too advanced as well when pinging on the 8th gen ECU. Maybe we need to revisit the knock sensor?
    Irvin likes this.

Share This Page