1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Engine Rod cap torque specs needed!

Discussion in 'Powertrain' started by starion88esir, May 13, 2005.

  1. Offline

    starion88esir Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Rod cap torque specs needed!

    I need to know the torque specs on the rod caps for a 2001. I found my bad bearing. Only one of them too. Go figure. Well, I've got a whole new set (all 8 bearings) and I will be polishing the crank tomorrow. Just going to be waiting for the bearings to come in (should be Monday). Then hopefully all will go smoothly and it will be put back together Monday and ready to be broken in. But I need the torque specs on the rod cap bolts. TIA.
    starion88esir, May 13, 2005
    #1
  2. Offline

    starion88esir Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    WOW!!! Not a single person knows? Guess I'll just wing it then.
    starion88esir, May 17, 2005
    #2
  3. Offline

    CorollaULEV Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Go here:

    www.trixology.org/Repair

    This is for the 03+ Corolla/Matrix 1ZZ-FE. Otherwise, just don't know. The PROCEDURE is the same, just not sure about the specific torque value.

    Trav
    CorollaULEV, May 17, 2005
    #3
  4. Offline

    rolla96dx New Member

    Message Count:
    172
    Likes Received:
    0
    Trophy Points:
    0
    either get a manual (or just flip through one at the store) or call a dealership and just ask. couldn't tell you off the top of my head...
    rolla96dx, May 18, 2005
    #4

Share This Page