Engine Results of the Digimoto scan on my '03

Results of the Digimoto scan on my '03

Ignition ON withOUT engine running:

ignition timing is 5º
long-term FT is -4.69%

Engine running:

Fully warmed up and idling, my ignition timing is ~ 15ºBTDC.
Coolant temp runs around 195ºF (cooling fan turns on around 205ºF I found out).
Target idle speed must be around 700rpm, since that's where it hangs.
Calculated load is around 15% @ idle.

I can also look at IAT, speed, O2 sensor voltages, MAF sensor values, and a few other nick-nacks.

Can do the DTC's and turn off the CEL and reset codes. If I can figure out a way to get serial RS232 connectivity for my PDA, then I'll be able to take it on the road - from that the program will calculate 1/8 and 1/4 times, calculate hp and torque...other nifty things like that.

Late,
Trav

Hey man, are you using ELM Scan ??
do you mind sending me the Digimoto software??
I have ELM Scan, but i don't ahve good software to go with it.