1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Reciever surround removal

Discussion in 'Interior' started by Brooks2741, May 22, 2005.

  1. Offline

    Brooks2741 Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Reciever surround removal

    I've got a Sony reciever in my 99 corolla right now and need to take it out to put in my other car. Best Buy installed it last september and I failed to watch them do it. I was wondering how to take the plastic surround off without breaking the small clips or whatever is holding it on. From there I believe I can handle it. Thanks.
    Brooks2741, May 22, 2005
    #1
  2. Offline

    scrotarolla Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Take a small flathead screwdriver and GENTLY pry the bottom out. There are 2 slots on the bottom that I used, that's where the clips are. when you've got the bottom out slide your fingers around the bezel until the whole thing pops out.

    Installation is reverse of removal. :p Just push it back in.
    scrotarolla, May 23, 2005
    #2
  3. Offline

    asn13oy Stepping Stones

    Message Count:
    683
    Likes Received:
    0
    Trophy Points:
    18
    Location:
    OC, CA
    I just stick my fingers up on top and pull...yanks right off. Kinda hard to break those clips.
    asn13oy, May 24, 2005
    #3

Share This Page