1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Engine Quick Shiffter

Discussion in 'Powertrain' started by diegoval, Jun 17, 2004.

  1. Offline

    diegoval Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Quick Shiffter

    hey i just bought a trd quick shifter so i was wandering if any one knows how to install it.

    any help would be really appreciated
    diegoval, Jun 17, 2004
    #1
  2. Offline

    SkyAce2004 New Member

    Message Count:
    885
    Likes Received:
    0
    Trophy Points:
    0
    if its for a 98 gimmie a hollar on any of the instant messaging devices listed in my profile
    SkyAce2004, Jun 17, 2004
    #2
  3. Offline

    Mike4831 C-Town Pimp

    Message Count:
    1,265
    Likes Received:
    1
    Trophy Points:
    0
    Location:
    Statesboro, GA
    well ur going to need to get under the car. i have helped install 3 of them. all were done on the lift at honda. if you dont have access to one. ummm. i wouldn't try it.
    Mike4831, Jun 17, 2004
    #3
  4. Offline

    SkyAce2004 New Member

    Message Count:
    885
    Likes Received:
    0
    Trophy Points:
    0
    wtf are u talking about? u dont need to get under the car to install a TRD quick shift into a corolla...atlease not for the 98-02 models... all u gotta do is take out the center consol
    SkyAce2004, Jun 17, 2004
    #4
  5. Offline

    kepone Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    lol, i dont think theres a short shifter on the planet that requires a lift to install...
    kepone, Jun 17, 2004
    #5
  6. Offline

    moedank Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    moedank, Jun 17, 2004
    #6
  7. Offline

    Mike4831 C-Town Pimp

    Message Count:
    1,265
    Likes Received:
    1
    Trophy Points:
    0
    Location:
    Statesboro, GA
    well the cars i did we an 95 gsr, 96 integra, and an 03 tiburon. none of which we corollas.
    Mike4831, Jun 18, 2004
    #7
  8. Offline

    SkyAce2004 New Member

    Message Count:
    885
    Likes Received:
    0
    Trophy Points:
    0
    yaah, u gotta take apart the bottom part of the dash and the center consol. then u gotta unbolt the shifter, take out the 2 rods ( C-clips, have fun geting those out) and then there should be 4 over-thicked washers that are ment to extend the quickshiter above the frame. u put them where the shifter bolts, and then put the shifter on top of that.

    those pix provides make u think its a shorter stick, but its not. its just the joint is placed higher up on the stick to give it a shorter throw. the height will be exactally the same
    SkyAce2004, Jun 18, 2004
    #8

Share This Page