New headunit installed...but problems

New headunit installed...but problems

hi, just finished installing my new headunit. However, after using a screwdrive to pry off the trim panel, I left marks of the screwdriver in the plastic material...like dents. Anyway to regain the smoothness ? Maybe hairdry it to heat it up so it can pop back to original shape? Also, this is more annoying. The slider thing for fan speed control is now whack. I can pull it out like 1/4 inch with tweezers, but it always goes back inward. Also, I no lnger have the click click feel when I slide it. It also rarely shuts off when I slide it all the way left, but will sometimes if I jiggle it and I feel a solid click. Any ideas? Did i damage the thing? Fix? Thanks in advance

For the dent, DO NOT use a hairblower (not only it's gay, but it will morph the entire plastic bezel ) Your best bet is to sand it with very fine ~300 grit sandpaper, then polish it with a dash/interior restorer (Meguiars makes one)

As for your AC control, look under your dash and you will see steel-wire thingys (like a bike brake cable) that goes from your controls all the way to a "controller" deeper into your dash. The edge of this "wire" is usually clipped into something, and your cable must have been unclipped somehow. Just "clip" it back in and you're set.

LATER

Thanks! Will try tomo