1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Help! flashing direction lights and releasing trunk on the keyless entry system

Discussion in 'Other DIY & Questions' started by bombboygene, Jun 22, 2012.

  1. Offline

    bombboygene New Member

    Message Count:
    8
    Likes Received:
    0
    Trophy Points:
    3
    Location:
    Bay Area, CA
    Vehicles:
    Corolla 02
    Ok I'm thinking I should finish my first keyless entry project, but still could not figure out how to connect it to the parking light relay (or any other relay?) so that I can flash my direction lights once the cars locked.

    For the trunk release, don't have any ideas how to wire it to release the trunk. Do I have to peel the floor for this wiring?
    [IMG]
    Thanks for you help!!!:)
    bombboygene, Jun 22, 2012
    #1
  2. Offline

    1337Rolla oh my

    Administrator
    Message Count:
    3,979
    Likes Received:
    31
    Trophy Points:
    748
    First you would need to have an actual trunk solenoid. 98-06 rollas do not have one, unsure about other vehicles. You would hook that trunk (-) wire to a relay and the relay to 12V, the solenoid, and ground The direction light is applying 12V on that wire it looks like... you would connect that at the same spot the relay outputs 12V to the lights.
    1337Rolla, Jun 22, 2012
    #2

Share This Page