Engine Crank Pulley installation for 01 rolla

Crank Pulley installation for 01 rolla

Hi experts
have anyone out there installed the crank pulley of 01 rolla yet? is it hard?

thanx

Not too hard, but you will need the right tools. You need a crank pulley puller. Youll need an impact driver or hammer drill. You need a 19mm socket and at least a 4" extension. And a large cresent to hold the pulley in place(while its attached to the puller). It took me about 3 hrs to do the crank and alt pulley w/ one friends help. The difference? Revs quicker, seems not to drop off as easily when I coast and really pulls better between 3-4K.

Revs quicker..with the light flywheel, I don't think my cheap tach will be able to keep up anymore..

Unorthodox Racing or ASP? ASP is much cheaper, but OR is a full set..

just leave the car in gear, and use a breaker bar to get the bolt off...... once the bolt is off, you need a universal puller to get the pulley off.... pretty simple stuff (any auto shop should have one you can rent or buy).... once the old one is off, new one goes on as much as you can, then just tighten the bolt down to around 80ft lbs

im putting my OBX one on this saturday. I will take pics for a DIY prolly.

102 ft lbs. to be exact.