1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Corolla '99 Help!!!

Discussion in 'Interior' started by ChristianVA, Sep 11, 2005.

  1. Offline

    ChristianVA New Member

    Message Count:
    411
    Likes Received:
    0
    Trophy Points:
    0
    its reallly easy. get all the screws out and pop it off. pretty much the only hard part which is not it taking the c clip off the window crank handle.
  2. Offline

    VECorolla99 Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Thanx but how many screws should there be?
  3. Offline

    VECorolla99 Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Corolla '99 Help!!!

    I need help, i need to know how do you take the door panel off to get to the speakers in a rolla 99. Its a VE so its manual not electrical
  4. Offline

    fastcorolla New Member

    Message Count:
    24
    Likes Received:
    0
    Trophy Points:
    0
    3!
  5. Offline

    slvr2000fdvspec Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    take off the door handle - 1 screw
    door opening handle thing - 1 screw
    somewhere else - 1 screw
    slide the trim of the door opening handle thingy left or right and pull out
    turn the handle until you see this metal wire thing, use a flathead or panel popper and push it out but catch it cause that mofo flies far
    pull window crank handle out
    there are rivets all around the edge, so pop those
    after all done, push the panel UP and to the REAR of the car
    disconnect all wires
    place panel aside
    have a beer
    voila
  6. Offline

    Spone76 Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Yep it's not that hard I just but some speakers in my 00 last week.You are going to need a drill do get the rivits out of the speakers, or get a hammer to pull them out. Note: make sure the magnet doesn,t hit the window also the screw holes want line up.

Share This Page