1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Engine CAI options

Discussion in 'Powertrain' started by GTAXRS, May 7, 2006.

  1. Offline

    GTAXRS Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    CAI options

    Hi all,

    Newbie here. 2005 XRS (bone stock..... for now)

    I'm looking for a CAI for a 2005 Corolla XRS. Can't seem to find anything so I fiured I'd ask you guys as there is always so much goon info here.
    GTAXRS, May 7, 2006
    #1
  2. Offline

    Tamago New Member

    Message Count:
    585
    Likes Received:
    0
    Trophy Points:
    0
    look at celica CAI's

    slight modification should yield good results.?
    Tamago, May 7, 2006
    #2
  3. Offline

    JCturbo 9THGEN GURU

    Message Count:
    69
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    La Habra, Orange County CA

    NO!!! are you on crack??!?!?! only internals and physical engine parts are the same from Celi to Rolla. if you want Intake look up 2004 Matrix XRS. Greddy Makes SP2 and EVO2 axle back exhaust's for us as well

    Here's my 05 XRS with Injen CAI P/N RD2076BLK

    [IMG]

    here's a vid show-boating the Intake and exhaust
    http://s28.photobucket.com/albums/c...newbeast009.flv
    JCturbo, May 7, 2006
    #3
  4. Offline

    rainbow_star New Member

    Message Count:
    2,387
    Likes Received:
    3
    Trophy Points:
    588
    Nice headlight JCturbo! :D
    Yea, go look for matrix XRS CAI, it fit rolla XRS.
    rainbow_star, May 8, 2006
    #4
  5. Offline

    Tamago New Member

    Message Count:
    585
    Likes Received:
    0
    Trophy Points:
    0
    no actually i'm not on crack.. notice the ? in my post?


    :sigh:
    Tamago, May 8, 2006
    #5
  6. Offline

    admayen Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    So the cold air intake for a matrix xrs fits the corolla xrs right? I've been looking and I to can't find one for the rolla xrs. Can anyone confirm this? Does anyone have any pictures of a rolla xrs with a cold air intake intended for a matrix xrs?
    admayen, Jul 19, 2006
    #6
  7. Offline

    rainbow_star New Member

    Message Count:
    2,387
    Likes Received:
    3
    Trophy Points:
    588
    100% sure.
    You can go 9thgen and find some pic.
    rainbow_star, Jul 20, 2006
    #7
  8. Offline

    hawaii New Member

    Message Count:
    184
    Likes Received:
    0
    Trophy Points:
    0
    LOL
    hawaii, Jul 20, 2006
    #8
  9. Offline

    JCturbo 9THGEN GURU

    Message Count:
    69
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    La Habra, Orange County CA
    That picture in my above post is with Injen P/N RD2076 *intended for 2004 Matrix XRS*
    JCturbo, Jul 21, 2006
    #9
  10. Offline

    admayen Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Just got it and installed it. It certainly does fit. However, there were some minor problems with the install. I guess I'll have to check other forums on the proper installation and modifications needed to fit the Corolla XRS.
    admayen, Jul 29, 2006
    #10
  11. Offline

    admayen Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Hey, did you cap off the breather on the intake pipe by the CARB EO sticker? Shouldn't it have a rubber hose about an inch thick coming out of the intake and going down towards the fender somewhere.
    admayen, Jul 29, 2006
    #11
  12. Offline

    JCturbo 9THGEN GURU

    Message Count:
    69
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    La Habra, Orange County CA
    correct I capped it off....it's not necessary. the air pump can draw from the atmosphere without issue
    JCturbo, Jul 30, 2006
    #12

Share This Page