1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Engine All Corolla Forged Piston Set W/ Rings And Bearings

Discussion in 'Powertrain' started by PSyChO cHilD, Mar 20, 2005.

  1. Offline

    PSyChO cHilD Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    PSyChO cHilD, Mar 20, 2005
    #1
  2. Offline

    corolla_man_j Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    too bad that doesn't include the rods eh? Man I saw some titanium rods this week....they were smaller than ours, but they were for a 4 cylinder indy car, which they run around 60+ psi....and their turbos are pretty massive....the guy that rebuilt my t25 is a sponsor for INDY/CART and the had one of their turbos
    corolla_man_j, Mar 20, 2005
    #2
  3. Offline

    JspeXAE102 Well-Known Member

    Message Count:
    4,851
    Likes Received:
    15
    Trophy Points:
    588
    Location:
    群馬 日本
    I believe paulter offer rods
    http://www.raceeng.com/

    it's nice that they offer different bores. but whats the ideal comp ratio i dunno? 8:1?

    Also you could save a bit of money by using 4AGZE pistons, unfortunitely noone here knows the exact comp ratio when installed in a 7A block.

    PSI Racing probably knows best about building 7afe's
    http://www.psiracing.com/
    JspeXAE102, Mar 20, 2005
    #3

Share This Page