1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Engine Ah, an intake question

Discussion in 'Powertrain' started by Fgca_rolla, Dec 29, 2005.

  1. Offline

    Fgca_rolla milky cocopuffs

    Message Count:
    808
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Fort Myers, FL
    Ah, an intake question

    Bare with me while I explain this. I just put in my AEM SRI Intake. I had an ebay BS one before, but was getting sick of it so I bought the AEM one. With the AEM directions there was something about mounting a VSM (?) bracket. It looked like all it did was hold one of the sensors, but the instructions were really vague and I couldn't figure out where to put the bracket. Any one have an 03 or 04 rolla with an AEM SRI that knows what the f*ck that bracket is about? Or hell, if you know where to actually mount it that would be rad too.

    Thanks.
    Fgca_rolla, Dec 29, 2005
    #1
  2. Offline

    sxlostv1 New Member

    Message Count:
    1,271
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Los Angeles
    maybe mounts to the holes where the airbox mounts to the car???
    sxlostv1, Jan 1, 2006
    #2
  3. Offline

    Denver Rolla 98 impreza

    Message Count:
    2,887
    Likes Received:
    0
    Trophy Points:
    588
    Location:
    Lakewood, CO
    show us what it looked like... if its what I'm thinking of its where you mount the vacume control unit and that goes on the drivers side strut tower.. on the side of it... there are holes where the old air box used to mount to... but I could be wrong its been almost a year and a half sence I installed my intake...
    Denver Rolla, Jan 1, 2006
    #3

Share This Page