1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

AE101 Rear Disc Conversion DIY

Discussion in 'Stop, Drop & Roll' started by Vamp, Jun 8, 2005.

  1. Offline

    Vamp Gunmetal 2001 Corolla S

    Message Count:
    1,756
    Likes Received:
    21
    Trophy Points:
    588
    Location:
    Rosedale, MD
    Vehicles:
    Gunmetal Grey 2001 Corolla S
  2. Offline

    ctam1986 Chicken

    Message Count:
    372
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Orange County, CA
    thank you VAMP
  3. Offline

    ctam1986 Chicken

    Message Count:
    372
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Orange County, CA
    oh! did hazer00 sell his side skirt and rear bumper?
  4. Offline

    j-rolla02 Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    What size are the rotors in relation to the front? And, if I cant find AE101 brakes, what about MR-S rears??
  5. Offline

    starion88esir Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    Where were you able to source the rear brake setup from?
  6. Offline

    PSyChO cHilD Guest

    Message Count:
    0
    Likes Received:
    0
    Trophy Points:
    0
    -Side skirts and rear bumper are gone.

    -The rear brake discs are noticeably larger then the front, however the pads are smaller.

    -Kit was sourced from Dr.Tweak on VVt-i.net
  7. Offline

    RedAE102 New Member

    Message Count:
    44
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Cypress, CA, USA
    Standard E10/E11 14" wheel 4-wheel disc brake size is 255 mm front (~10 inches) and 266 mm rear (~10½ inches).
  8. Offline

    asn13oy Stepping Stones

    Message Count:
    683
    Likes Received:
    0
    Trophy Points:
    18
    Location:
    OC, CA
    firefox doesn't like that page vamp....but IE works.

Share This Page