When my MAF sensor failed I had a CE light after accelerating onto the highway, I reset with battery and it returned after climbing a hill. The...
I have a voltmeter in my car, It seems if there is no or not as much of a load the voltage drops down (maybe to keep from overcharging ?) Since you...
Front or rear wheel ?? Rear can be done without too much work. Front requires pulling the caliper off. The stud (or whats left can be punched out)...
Have you tried any premium gas to see if it goes away ?? Take out a 2nd mortgage and try a little to see. My last 2 Corollas would spike in...
Use #168 bulbs, they look great in the clusters.
The MAF is right on top the air box, quick replacement. When my MAF was bad I had a CE light after accelerating intermittently, no change in...
It is similar to a brake switch, I would wire it over to test and maybe permanent. You could have the classic Toyota starter going bad.
Cluster only $40 Cluster & Sensor $65 shipped, Cash or M/O
For illumination ?? # 194 or 168 bulbs. 168s look great. 3 are used, twist sockets to left to remove. (the larger sockets are illumination)
Some add-on recievers offer FM modulation to allow use with exsisting system (not sure of quality) If your Pioneer is XM ready you can get the XM...
Put the lugs on but not super tight and drive back and forth. Rubber mallot. Put a ring of grease around the inside hole and it won't happen again.
Part # 83482-02010 Sensor outer ambient www.1sttoyotaparts.com Make sure it clicks in place when you install it. It is a tight fit on the plug.
If you remove the lower cushion it will reveal the screws for the back cushion. You lift the lower cushion while pushing back at the left and right...
Mine will dim slightly and more once the window is all the way up and has stopped. I consider it normal.
My wipers slow somewhat. My fan does not drop in speed at idle as much as my previous jap models did, very slight. 00 Corolla Have you watched it...
Remember that, DIODES CAN EXPLODE !! There is a lot of info at ---- > www.lsdiodes.com
^^ That makes sense, would be tough to DIY
Looks good, IMO How did you get the turn signal lenses clear ?
If you don't take the needle off it will be o.k.
In that enviroment they can work loose and cause all sorts of problems. The splice or butt connectors are the ones I always had trouble with. They...
Separate names with a comma.
