1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Engine Rear oxygen simulator from URD

Discussion in 'Powertrain' started by pupo, May 31, 2006.

  1. Offline

    pupo New Member

    Message Count:
    101
    Likes Received:
    0
    Trophy Points:
    0
    Rear oxygen simulator from URD

    I bought a rear oxygen simulator for my 2002 Corolla, it has three wires, has anyone instaled this thing before? The instructions that came with it were for a Tacoma.
  2. Offline

    JLee TD05 3SGTE

    Message Count:
    1,810
    Likes Received:
    5
    Trophy Points:
    588
    Location:
    NH
    Heh -- I bought both of my o2 sensors from URD.

    Three bare wires or a plug? I would assume installation for the Corolla would be similar to the Tacoma...
  3. Offline

    pupo New Member

    Message Count:
    101
    Likes Received:
    0
    Trophy Points:
    0
    No, is a rear oxigen sensor simulator, it does not replace the actual o2 sensor, is supposed to simulate the right signal from the o2 sensor so that you don't get the CEL when you change your catalic converter.
  4. Offline

    JspeXAE102 Well-Known Member

    Message Count:
    4,851
    Likes Received:
    15
    Trophy Points:
    588
    Location:
    群馬 日本
    you usually just install it between the sensor wire and ground the last wire.
  5. Offline

    pupo New Member

    Message Count:
    101
    Likes Received:
    0
    Trophy Points:
    0
    I got it instaled today. The wire that you need to cut is a red wire and the wire left that is black, goes to ground or to the brown wire in the plug where the o2 sensor plugs to.

Share This Page