Forced Induction 9-gen Supercharger

9-gen Supercharger

Other than the hood clearance problems, will the 1ZZ-FE TRD supercharger for the 9-gen Corolla bolt right up and work on an 8-gen?

I wonder what a hood cutout would look like on an 8th gen?

i think if you did the cut out right it would look hot

Yeah. I'm thinking something WRX-ish. :rally:

You could do a functional scoop type deal.... Did that adapter for that S/C finally make it out here to fit the 8th gens?

The bulge will look gay since it's not in the center of the hood either side to side or top to bottom.

They have adapters to make it fit from a while back.

you might as well just cut a hole in the hood and call it a day like hasport did for their EF.

the cut out should look something like this

Sunroof for your hood? LOL

instead a subby scoop,i rather do this

if I did that were I used to live they would steal the cables just because they're jealous... they're even jealous of my rolla, throwing gummy worms in the middle of the day and scratching it's paint

Wow sunroof for your hood!! So anyone can put sand into your engine anytime!

that will look gay, i wouldn't wanna advertise my goodies. you might as well be a honda and drive with no hood.

Like a bimbo with no top on.

I like.

That's dumb lol.... what if it rains or people start cutting ur shit up lol.... PHAIL! lol

I'm more worried about aerodynamics.

what if it was cut out like that with a low profile scoupe kinda like the new wrx ones but wide if you get what im saying

But for what purpose? Induction on a non-turbo car? Pointless.

to make room for the super charger have it set up like the newer older minis the air going in through the scoupe will help it out alot as well

think smart and not hard...

still a phail on my book lol..... There's a GB on some TRD S/C's going on at 9thgencorolla right now. They're $2850 shipped with a minimum 5-6 buyer list

2850? That's almost the KBB of my car. LOL

not only will you need engine mgnt, but you'll need to to a few other customs..like throttle body..

Bolt on problems have already been solved. Adapters are available to make it work. Hood clearance is the only issue.

The CarverCharger is the only supercharger that fits perfectly under the Corolla hood. Too bad the project stalled a couple years ago. I can't get in contact with Carver anymore.