1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Engine Tranny screaming..or so I think

Discussion in 'Powertrain' started by eddy, Mar 28, 2009.

  1. Offline

    eddy Well-Known Member

    Message Count:
    503
    Likes Received:
    0
    Trophy Points:
    468
    Tranny screaming..or so I think

    Its been a while since I've posted a "Problem" since I've been enjoying a pretty smooth almost new car after I got a new engine installed few months ago. I've got a killer 160K on my 01 Prizm now (new engy came in at 151K) and few days ago, I started noticing a weird scream/grind/chatter like noise every time I accelerate. Its very distinct when taking off from a complete stop and at those in between gears shift speeds (like when its about to shift a gear up as you're speeding up). What could be causing this, tranny? flywheel? clutch? I wanna find out before I take it in somewhere and I know of no better place to ask than here. Any and all help is appreciated..
  2. Offline

    1337Rolla oh my

    Administrator
    Message Count:
    3,979
    Likes Received:
    31
    Trophy Points:
    748
    do you hear it only when in gear and not out of gear? if so , tranny is going
  3. Offline

    nyrican52884 Active Member

    Message Count:
    965
    Likes Received:
    0
    Trophy Points:
    38
    Location:
    Plymouth, MA
    So you got a new engine and didn't replace the clutch? The flywheel is just a piece of metal. I don't think it can go bad.
  4. Offline

    GSE21tuner Formerly rollatuner110. Representing AZLexus.club

    Message Count:
    10,948
    Likes Received:
    19
    Trophy Points:
    568
    Location:
    Phoenix, AZ
    Vehicles:
    07 Lexus IS350, 04 Lexus IS300
    It can actually. After normal wear, teeth from it can break off.
  5. Offline

    JspeXAE102 Well-Known Member

    Message Count:
    4,851
    Likes Received:
    15
    Trophy Points:
    588
    Location:
    群馬 日本
    well the flywheel should be able to last for at least 2 resurfacings or 200K.

    It could be that the clutch is not being released all they way.. so master cylinder? slave cylinder? clutch fork? or release bearing? Have someone push the clutch while you watch the slave cylinder to clutch fork contact points to make sure everything is functionng properly.
  6. Offline

    toyotaspeed90 New Member

    Message Count:
    918
    Likes Received:
    9
    Trophy Points:
    588
    Location:
    Bellingham, WA
    the hydraulics won't hold the pressure plate back (ie not being released all of the way) unless there's a problem with how the fork is installed. The hydraulics should always return back to normal -- both the slave and the master have springs that make it do this, along with the pressure plate should push on the fork to allow the hydraulics to release.

    if you're hearing chatter it could be from a leaking rear main and the clutch isn't grabbing, or it could be from the engine getting too hot and there are hot spots on the flywheel.
  7. Offline

    xplicitcorolla99 Active Member

    Message Count:
    2,201
    Likes Received:
    0
    Trophy Points:
    38
    Location:
    las vegas
    its gotta be your tranny gone or clutch breaking into pieces slowly while you drive.
  8. Offline

    eddy Well-Known Member

    Message Count:
    503
    Likes Received:
    0
    Trophy Points:
    468
    Dunno if this helps but mine is a 3speed auto. I hear the scream every time I accel. and it stops for a few secs, then I hear it again and I feel it shifting to the next gear. So am I looking at a dying clutch or the whole tranny?
  9. Offline

    1337Rolla oh my

    Administrator
    Message Count:
    3,979
    Likes Received:
    31
    Trophy Points:
    748
    have you checked the tranny fluid level? since it's an auto it may be having trouble opening/closing valves if it's low

    I've tried driving an auto tranny before 2 quarts low.. shifted but kicked horribly, 1 quart low.. whined as it shifted
  10. Offline

    eddy Well-Known Member

    Message Count:
    503
    Likes Received:
    0
    Trophy Points:
    468
    When I got my new engine, I got a full tranny drain and new fluid filled. Although I havent checked the level lately. I'll do that today before leaving work and post back. Hope its just this simple..and not a big prob
  11. Offline

    toyotaspeed90 New Member

    Message Count:
    918
    Likes Received:
    9
    Trophy Points:
    588
    Location:
    Bellingham, WA
    So is this car an auto or a 5 speed?
  12. Offline

    eddy Well-Known Member

    Message Count:
    503
    Likes Received:
    0
    Trophy Points:
    468
    Hope that helps.
  13. Offline

    toyotaspeed90 New Member

    Message Count:
    918
    Likes Received:
    9
    Trophy Points:
    588
    Location:
    Bellingham, WA
    FYI, if you have an auto you do not have:

    clutch
    flywheel
    pressure plate
    clutch hydraulics

    so none of those can be a problem.

    You have a flexplate that has the torque converter bolted to it.... the flexplate cannot be the fault.

    just an FYI.
  14. Offline

    eddy Well-Known Member

    Message Count:
    503
    Likes Received:
    0
    Trophy Points:
    468
    Checked tranny fluid, looks good, so one hypothesis eliminated.

    Didnt know any of that, a lot of hypotheses eliminated.

    So what could possibly causing the screaming? Should I be paranoid and take it in ASAP?
  15. Offline

    fishexpo101 Get Some

    Message Count:
    1,087
    Likes Received:
    3
    Trophy Points:
    488
    Location:
    Northern Virginia
    Take it in - either have a competent mechanic/dealership look into it or have the people that installed the replacement engine check to make sure they didn't mess the transaxle up.
  16. Offline

    xplicitcorolla99 Active Member

    Message Count:
    2,201
    Likes Received:
    0
    Trophy Points:
    38
    Location:
    las vegas
    post up a vid or something so we all can hear the problem

Share This Page