what do you guys think of these specs???

what do you guys think of these specs???

what do you guys think of these specs???

once in site go to TECH support then 2003 then theile small parameters then ultra excursion
http://www.audiobahninc.com/frame2004.html

with 2 of them pushed with a 1800RMS x1 audio baun

Two of what...? What model?

these but go to that site above in my first post and follow those steps to go to more specific steps
http://www.etronics.com/product.asp?stk_code=audaw1205q&store=&catid=369

They're theile small parameters - there's no such thing as good or bad specs. These parameters just decribe the elecrto-mechanical properties of the speaker and don't mean much as far as quality of sound goes. You are going to need some prretty big boxes...

How are you planning to wire these? With your amp they'll end up getting about 600 W RMS each.

i'm going to run them at 1 ohm

If you run them each at 1 ohm and wire them in series, you'll have 2 ohms total load and the amp will deliver 1200 W (600 W to each driver).

If you run them each at 1 ohm and wire them in parallel, you'll have 1/2 ohms total load and the amp will be beyond its capacity. Hard to say whether the drivers or the amp will blow first.

Go with a total 2 ohm load. You can either run the drivers at 1 ohm each and wire them in series, or run the drivers at 4 ohms each and wire them parallel. Either way the amp will see a 2 ohm load.

They will sound like absolute crap but get extremely loud. I had to "high excursion" 12's and they were alright sounding untill about half volume and then it just got loud 8)

what if i got subs that ran at 3 ohm? What would 2 subs ran at that bring the final load to the amp?????????? will these sound and run good with that amp?????

speakers
http://www.etronics.com/product.asp?stk_code=audalum12q&store=&catid=369

Amp
http://www.millionbuy.com/adba18001dt.html

when it said 4 at 1800x1 they mean 1 ohm

OK first of all here's a link to the best web site for car audio. This is how i figured it out.
http://www.bcae1.com/

Second now i need advice if i got three of these speakers and the way i figured they should all get 600 watts rms to them how will they sound? has any one ever ran a system like this and if so what can i expect?