1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Engine engine swaps for 8th gen

Discussion in 'Powertrain' started by lilxhksxboi, Feb 9, 2007.

  1. Offline

    lilxhksxboi New Member

    Message Count:
    18
    Likes Received:
    0
    Trophy Points:
    0
    engine swaps for 8th gen

    Has anyone put a 4a-ge silvertop or blacktop or 3s-gte into the 8th gen before? If so, how easy or how hard was it to swap in? I am planning on doing the swap and need some advice for it, i can get the motor or the complete front clip but i have little or no information on where the mounts go and what little parts i will need.
  2. Offline

    Mayur Biggest trd whore in the whole wide world

    Message Count:
    1,723
    Likes Received:
    0
    Trophy Points:
    38
    Location:
    Des Plaines, IL
    3sgte has been done and there are some models in japan that came with the 4age. 3sgte, I only know one person who has it done and I still think there is some work left on it. I say go for a 2zz-ge.
  3. Offline

    lilxhksxboi New Member

    Message Count:
    18
    Likes Received:
    0
    Trophy Points:
    0
    I can't find a 2zz-ge for cheap, most of the places that i know of that can get me clips or complete engines don't carry a 2zz.
  4. Offline

    cgreen38 Common sense, p

    Message Count:
    1,057
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Baton Rouge, LA
    2zz is the easiest swap. Just change wiring and beat back firewall a bit for header clearance.
  5. Offline

    Dr Tweak Mad Scientist

    Message Count:
    1,237
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Savannah, GA
    The blacktop would be the number one easiest swap. The 2ZZ has some challenges but is a good option if you want or need to stay OBD2. The 3SGTE is by far the best option for power, but would be the most difficult swap to do.

    -Doc
  6. Offline

    JspeXAE102 Well-Known Member

    Message Count:
    4,851
    Likes Received:
    15
    Trophy Points:
    588
    Location:
    群馬 日本
    DOC, do you know if the factory axles from a 96 corolla would mate up to a C160 6spd tranny from a blacktop?

Share This Page