1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

Forced Induction Boost Sensor

Discussion in 'Powertrain' started by Barnacules, 2007年07月09日.

  1. Offline

    Barnacules 100101101011011

    Message Count:
    2,933
    ライク受信:
    1
    賞:
    0
    Location:
    Duvall, WA
    Boost Sensor

    My Greddy eManage boost sensor failed, it now is stuck at 29psi and wont seem to budge more then a psi or two in either direction. Can I tap the sensor wire from the emanage harness off the Apexi AVC-R boost sensor so I only have one sensor in the system?
    Barnacules, 2007年07月09日
    #1
  2. Offline

    LoSx New Member

    Message Count:
    327
    ライク受信:
    0
    賞:
    0
    Well technically the avc-r I believe runs off a 0 - 5 v sensor like the emanage the problem is that moltage may not line up...

    the apeci may be a 2 bar system while the emanage is a 3 bar system...

    I believe there are cheap emanage boost sensor (not sold by emanage) but by GM or something that you can find around.
    LoSx, 2007年07月09日
    #2
  3. Offline

    SaberJ2X Lurk MOAR

    Message Count:
    1,713
    ライク受信:
    7
    賞:
    398
    Location:
    Mayawest, PR
    GM ones are the ones my friend use on his turbo honda builds
    SaberJ2X, 2007年07月09日
    #3
  4. Offline

    Barnacules 100101101011011

    Message Count:
    2,933
    ライク受信:
    1
    賞:
    0
    Location:
    Duvall, WA
    Any idea where I can find the 3 bar GM sensor? I would like to buy one and get this bad boy back on the road again :)
    Barnacules, 2007年07月09日
    #4
  5. Offline

    SaberJ2X Lurk MOAR

    Message Count:
    1,713
    ライク受信:
    7
    賞:
    398
    Location:
    Mayawest, PR
    junk yard? some generic auto part stores

    just ask for a 3bar GM map sensor I think they are 3 cables
    SaberJ2X, 2007年07月09日
    #5

TRDの愛を広める