Cosmo Racing Intake

anyone know if this is able to fit the 99 1zzfe? From what I here only difference is my throttle body is smaller since i still havnt swapped to the plactic manifold and tb and the maf sensor has to be welded closed. Ive seen some people have tried it on toyotanation but never posted the results. Thanks I appreciate it

I'm pretty sure it would fit, even if it didnt it would be off only by a little and i'm sure you could jerry rig it to fit.

would it fit through that hole that goes down to the resonator?

Yeah, its plenty small enough.

I was thinking of just sawing off the maf sensor since my engine doesnt have one and stick a bypass valve as a precaution. What do you guys think i know its going be hard to get water into my motor to hydrolock but better safe than sorry

You and press should join a club.

do you think there would there be any cel issues? Sorry for your loss gold

He will come back, dont worry. He will get bags or something and comes back to the corolla forums to make all the corolla owners jelly.

GOLD!! LMFAO, my cat just jumped up on the tv stand and started attacking your pokemon gif ahahaahahah.

sorry, i've been drinking, that was hilarious to me.


Added: Feb 6, 2013 at 11:25 PM

Added: Feb 7, 2013 at 12:40 PM
so i figure this would be the best route to go with!

I have an el prototypes intake and had to install bypass , I too have have almost stalled due to water suction all I added to filter was an ingen water shield

So did you cut the the intake in half?

Is the heat shield and water shield the same?

No I did not cut it I have a really long k&n filter cut that and added pipe

is it even installed mack? last time i checked it was in your storage locker

M

My penis is installed in your mouth.

well douchy....you know the rest