1. Welcome to TRD Forums! A community for Toyota, Lexus, and Scion Enthusiasts. To enjoy all the benefits of the site, we invite you to signup.

8th Gen (98-02) Showoff

Discussion in '8th Gen' started by Shifty, Mar 29, 2006.

Thread Status:
Not open for further replies.
Page 145 of 279
  1. Offline

    roachrolla Hipster

    Message Count:
    4,501
    Likes Received:
    360
    Trophy Points:
    533
    Location:
    BROOKLYN, NY
    Vehicles:
    02 Toyota Corolla
    punishment to all of you for leaving!
    roachrolla, Apr 28, 2012
    #4321
  2. Offline

    Press22 Mangoooooooooooo

    Message Count:
    2,235
    Likes Received:
    356
    Trophy Points:
    143
    Location:
    Las Vegas, NV
    Vehicles:
    E28 1JZ, E36 M3
    I'm on here all day and I stay lost
    Press22, Apr 28, 2012
    #4322
    SEIGE likes this.
  3. Offline

    ilovecorollale Well-Known Member

    Message Count:
    167
    Likes Received:
    23
    Trophy Points:
    228
    For reals??? Wouldn't ur car be like slammed down it really doesnt look that low though.
    ilovecorollale, Apr 29, 2012
    #4323
  4. Offline

    MacktasticSlick TRD whore with 36,000 posts, bitch

    Administrator
    Message Count:
    36,593
    Likes Received:
    2,274
    Trophy Points:
    61,368
    Have you seen how high these cars are stock? lol. Maybe it's the angle of the pics, it's pretty low. I can't go over speed bumps normally, and the underside is pretty banged up.
    MacktasticSlick, Apr 30, 2012
    #4324
  5. Offline

    Press22 Mangoooooooooooo

    Message Count:
    2,235
    Likes Received:
    356
    Trophy Points:
    143
    Location:
    Las Vegas, NV
    Vehicles:
    E28 1JZ, E36 M3
    Your car doesn't look like it was any lower than mine mack and I don't think I was 4 inches lower. We had the same wheel specs too
    Press22, Apr 30, 2012
    #4325
  6. Offline

    MacktasticSlick TRD whore with 36,000 posts, bitch

    Administrator
    Message Count:
    36,593
    Likes Received:
    2,274
    Trophy Points:
    61,368
    Well maybe my car was higher than it should have been stock, but I doubt it since my struts were blown.
    MacktasticSlick, Apr 30, 2012
    #4326
  7. Offline

    Goldy Well-Known Member

    Administrator
    Message Count:
    32,004
    Likes Received:
    2,876
    Trophy Points:
    61,468
    The only thing you changed was the springs, right? Tein S-techs and you cut the fronts? The drop would be 1.5" rear and 2"+ your cut in the front.
    Goldy, Apr 30, 2012
    #4327
  8. Offline

    MacktasticSlick TRD whore with 36,000 posts, bitch

    Administrator
    Message Count:
    36,593
    Likes Received:
    2,274
    Trophy Points:
    61,368
    The rears are cut too.
    MacktasticSlick, Apr 30, 2012
    #4328
  9. Offline

    Hummer Well-Known Member

    Message Count:
    26,893
    Likes Received:
    1,455
    Trophy Points:
    1,018
    Location:
    Oregon
    Vehicles:
    E39 BMW
    Hated cut springs, front bottomed out like golds personal life.
    Hummer, Apr 30, 2012
    #4329
    1nicetrd likes this.
  10. Offline

    Goldy Well-Known Member

    Administrator
    Message Count:
    32,004
    Likes Received:
    2,876
    Trophy Points:
    61,468
    yeah, it must've been Press that ended up with normal back springs? There are so many s-tech floating around this forum I can't keep em straight.
    Goldy, Apr 30, 2012
    #4330
  11. Offline

    Press22 Mangoooooooooooo

    Message Count:
    2,235
    Likes Received:
    356
    Trophy Points:
    143
    Location:
    Las Vegas, NV
    Vehicles:
    E28 1JZ, E36 M3
    I never bottomed out my corolla. Hm...
    Press22, Apr 30, 2012
    #4331
  12. Offline

    MacktasticSlick TRD whore with 36,000 posts, bitch

    Administrator
    Message Count:
    36,593
    Likes Received:
    2,274
    Trophy Points:
    61,368
    ^^I'm thinking I'm lower than you were then. Not sure. Got a pic from the side that shows the lowest it was?
    MacktasticSlick, May 1, 2012
    #4332
  13. Offline

    nellfilipino Member

    Message Count:
    35
    Likes Received:
    7
    Trophy Points:
    8
    black rollas looking badass! heres a little update on my corolla late night work on it but still more work in the morning... [IMG]
    [IMG]
    nellfilipino, May 1, 2012
    #4333
  14. Offline

    Press22 Mangoooooooooooo

    Message Count:
    2,235
    Likes Received:
    356
    Trophy Points:
    143
    Location:
    Las Vegas, NV
    Vehicles:
    E28 1JZ, E36 M3
    I'll try finding one later. But I think it didn't bottom out cause I drive cautiously. I haven't even bottomed out in the BMW. Going all sideways and shit
    Press22, May 1, 2012
    #4334
  15. Offline

    Goldy Well-Known Member

    Administrator
    Message Count:
    32,004
    Likes Received:
    2,876
    Trophy Points:
    61,468
    I'll bottom out sometimes, if I hit a pothole going around a corner fast. The suspension hits the underneath of the car.
    Goldy, May 1, 2012
    #4335
  16. Offline

    RinconRolla98 Well-Known Member

    Message Count:
    1,533
    Likes Received:
    9
    Trophy Points:
    248
    Location:
    Rincon , Puerto Rico
    [IMG]
    [IMG]
    [IMG]
    [IMG]
    [IMG]
    [IMG]
    [IMG]
    RinconRolla98, May 1, 2012
    #4336
  17. Offline

    MacktasticSlick TRD whore with 36,000 posts, bitch

    Administrator
    Message Count:
    36,593
    Likes Received:
    2,274
    Trophy Points:
    61,368
    I'm pretty careful too, but like gold kinda stated, sometimes you can't avoid it.
    MacktasticSlick, May 1, 2012
    #4337
  18. Offline

    SEIGE Well-Known Member

    Message Count:
    424
    Likes Received:
    65
    Trophy Points:
    388
    Location:
    Bay Area, CA
    Vehicles:
    ZZE110
    NOOO! You just stole my look haha I was going for the same setup but I would have diff wheels
    SEIGE, May 1, 2012
    #4338
  19. Offline

    nellfilipino Member

    Message Count:
    35
    Likes Received:
    7
    Trophy Points:
    8
    lmao you can still do it! not trying to be cocky or anything but i think thats the best set up a corolla can have :D what wheels are you getting?
    nellfilipino, May 2, 2012
    #4339
  20. Offline

    Hummer Well-Known Member

    Message Count:
    26,893
    Likes Received:
    1,455
    Trophy Points:
    1,018
    Location:
    Oregon
    Vehicles:
    E39 BMW
    Nell, car looks great man you should consider doing a wire tuck!

    [IMG]
    Hummer, May 2, 2012
    #4340
  21. Offline

    nellfilipino Member

    Message Count:
    35
    Likes Received:
    7
    Trophy Points:
    8
    thanks! holy crap that engine bay is clean! lol I've always considered doing that but i heard those are super hard to do though
    nellfilipino, May 2, 2012
    #4341
  22. Offline

    Hummer Well-Known Member

    Message Count:
    26,893
    Likes Received:
    1,455
    Trophy Points:
    1,018
    Location:
    Oregon
    Vehicles:
    E39 BMW
    Yeah i bet it is, just looking at my engine bay I would have no clue where to start.
    Hummer, May 2, 2012
    #4342
  23. Offline

    bxman89 Well-Known Member

    Message Count:
    344
    Likes Received:
    22
    Trophy Points:
    48
    here my update
    [IMG]
    bxman89, May 2, 2012
    #4343
  24. Offline

    nellfilipino Member

    Message Count:
    35
    Likes Received:
    7
    Trophy Points:
    8
    yeah i know what you mean, it would be a nice lil project though no lie, I've seen some cars at car meets with that and there pretty much the talk of the meet -_-
    nellfilipino, May 2, 2012
    #4344
  25. Offline

    MacktasticSlick TRD whore with 36,000 posts, bitch

    Administrator
    Message Count:
    36,593
    Likes Received:
    2,274
    Trophy Points:
    61,368
    You can get a mil-spec harness from RyWire, but that's very $$$. You can do a part tuck on your own by putting the fuseboxes in the glovebox.
    MacktasticSlick, May 2, 2012
    #4345
  26. Offline

    jdmPRfreak Member

    Message Count:
    79
    Likes Received:
    11
    Trophy Points:
    8
    Location:
    Puerto Rico
    Where did u get that visor or bugflector from the hood??
    jdmPRfreak, May 2, 2012
    #4346
  27. Offline

    ilovecorollale Well-Known Member

    Message Count:
    167
    Likes Received:
    23
    Trophy Points:
    228
    That hood deflector is a GT Styling brand.
    ilovecorollale, May 2, 2012
    #4347
  28. Offline

    jdmPRfreak Member

    Message Count:
    79
    Likes Received:
    11
    Trophy Points:
    8
    Location:
    Puerto Rico
    where they sell it??
    jdmPRfreak, May 2, 2012
    #4348
  29. Offline

    CorollaGT Low & Slow

    Message Count:
    1,650
    Likes Received:
    129
    Trophy Points:
    613
    Location:
    Hillsboro OR
    carid.com
    CorollaGT, May 2, 2012
    #4349
    SEIGE likes this.
  30. Offline

    jdmPRfreak Member

    Message Count:
    79
    Likes Received:
    11
    Trophy Points:
    8
    Location:
    Puerto Rico
    Photo (1).jpg Photo (3).jpg Photo (4).jpg Photo (5).jpg V__6431.jpg WP_001365.jpg WP_001756.jpg WP_001876.jpg WP_001758.jpg Photo (2).jpg
    the one with blue lip is the most recent one...the blue one is my friend's rolla with some photoshot btw..not dropped like mine...and the green one fran's rolla,the grey one jony's rolla getting ready to!!a couple of shoots of my stretch tire 185/55/15 on 15x9 with -2 camber on the back ..and my fender fail...need more negative camber rush...
    jdmPRfreak, May 3, 2012
    #4350
Page 145 of 279
Thread Status:
Not open for further replies.

Share This Page