Sparco Harness bar & UltraRacing Rear Bar

Sparco Harness bar & UltraRacing Rear Bar

Finally got the harness bar and 3 weeks later got my ultra racing 4 point rear bar , Thanks you Evan ( NextGenTuning.com ) for the hard work getting it to me Great Job . You guys can hook up with Evan and he will get whatever you need with no problems I will back him up. :thumbup: I will try to install them over the weekend and post some pic `s.

Sexy. Will that(sparco harness bar) work for an 8th Generation Corolla?

Installation

well here we go guys
first drill your hole use the bottom seat belt bolt .





slap in bar and tighten the bolts.





strut bar



remove bottom bolt and put through strut bar holes.







then but nut and bolt on harness strut bar



after that done.




clears rollcage



Ultra racing rear bar.

remove back seat and look for 2nd hole on passanger side back seat. put the bolt through and use that to hold the bar in place so that you can drill the other 3 a towel can be used to hold the bar also inplace.





drill the last 3 holes you need then bolted down.









then done.

thx bro, i think you can this one is off a wrx and i was told that a civic can also be used.

looks very nice...how much was for everything??

how come you didn't just get a brace (harness bar) welded into your cage... would have looked better imo, and more sufficient.

doest look nice though, i wouldn't mind the rear addition if i keep mine long enough

to each there own bro, it does the job.